Kemppi Kempact Pulse 3000 - Manual (Page 7)

EN
Wire feed rolls
ø mm colour drawing pressing
Fe, Ss, Al,
V-groove 0.6 pale grey W001045 W001046
0.8/0.9 white W001047 W001048
1.0 red W000675 W000676
1.2 orange W000960 W000961
1.4 brown W001049 W001050
1.6 yellow W001051 W001052
2.0 grey W001053 W001054
2.4 black W001055 W001056
Fe, Fc, Mc,
knurled 1.0 red W001057 W001058
1.2 orange W001059 W001060
1.4/1.6 yellow W001061 W001062
2.0 grey W001063 W001064
2.4 black W001065 W001066
Fe, Fc, Mc,
Ss, Al,
U-groove 1.0 red W001067 W001068
1.2 orange W001069 W001070
1.6 yellow W001071 W001072
2.8 INSTALLATION OF WELDING GUN
Make sure the gun wire conduit and the contact tip match the manufacturer’s
recommendations for the type and diameter of wire you use. Too small a conduit may
overload the wire feed device and impede the wire feeding. Tighten the gun’s quick connector
to eliminate voltage loss. A loose joint will heat up the gun and wire heater.
NOTE! Never use defected gun.
2.9 MOUNTING AND LOCKING OF WIRE REEL
LOCKED OPEN
• Release locking nails of wire reel hub by turning locking knob a quarter round.
• Mount the reel at its place. Note rotating direction of reel!
• Lock the reel with locking knob, locking nails of hub remain to outside position and will
lock the reel.
5
Kempac
t P
ulse 3000, Kempac
tC
ool 10 / © Kemppi O
y / 1136