Kemppi Kempact Pulse 3000 - Manual (Page 15)

EN
When pressed simultaneously, the weld data buttons recall the wire feed speed on the display,
the welding voltage and welding current values which have been used when welding was
stopped.
3.3.5 Timer
intermittent welding
spot welding
The spot time is set immediately after pressing the switch button, on the display SPt. The
pause time is set accordingly, on the PSE display. The time is set using the Process Manager.
3.3.6 Adjustment of welding dynamics
For adjusting of MIG/MAG welding dynamics, the adjustment value dyn -9...0...9 is displayed.
The welding stability and quantity of spatter are affected by the welding dynamics control,
the 0-position is the recommended reference range. Values -9...-1 give a smoother arc and less
spatter, while values 1...9 give a rougher arc and increased stability, when using a 100% CO ₂
shielding gas when welding steel.
3.3.7 Remote control
Gun control, wire feed speed or welding power control is changed using RMT 10. Control of
the welding voltage or the length of the welding arc can be adjusted using the potentiometer
on the panel. Panel control, adjustments using the potentiometer on the panel.
13
Kempac
t P
ulse 3000, Kempac
tC
ool 10 / © Kemppi O
y / 1136