Kemppi Kempact Pulse 3000 - Manual (Page 10)

EN
2.14 COOLING UNIT (KEMPACTCOOL 10)
NOTE! Cooling liquid is injurious! Avoid also contact with skin or eyes. In case of injury, seek for
medical advice.
Cooling unit KempactCool 10 together with MIG-gun of Kemppi's PMT-W and MMT-W range
enables MIG welding with water-cooled gun.
The cooling unit is installed beneath the power source with screws and mounting plate.
Electrical connections are on the bottom of power source.
Electrical connection for the cooling unit:
The bottom of power source
1. 400 V
2. Control connector
3. Equipment earth
NOTE! Only an authorised electrician is allowed to install electrical connection!
Installation of cooling unit:
8
Kempac
t P
ulse 3000, Kempac
tC
ool 10 / © Kemppi O
y / 1136