Kemppi Kempact Pulse 3000 - Manual (Page 14)

EN
Fe-group
F1 F1 F1 0,8 mm Fe Ar + 18 % CO²
F2 F2 F2 0,9 mm Fe Ar + 18 % CO²
F3 F3 F3 1,0 mm Fe Ar + 18 % CO²
F4 F4 F4 1,2 mm Fe Ar + 18 % CO²
F5 0,8 mm Fe CO²
F6 0,9 mm Fe CO²
F7 1,0 mm Fe CO²
F8 1,2 mm Fe CO²
FA FA FA 1,0 mm FeMC Ar + 18 % CO²
FB FB FB 1,2 mm FeMC Ar + 18 % CO²
FD 1,2 mm FeFC Ar + 18 % CO²
Auto
20 20 1,0 mm CuSi3-A Ar 1,1 – 2,0
1 21 21 1,0 mm CuSi3-A Ar 2,0 – 2,6
2 22 22 1,0 mm CuSi3-A Ar 2,4 – 3,1
3 23 23 1,0 mm CuSi3-A Ar 3,0 – 3,6
4 24 24 1,0 mm CuSi3-A Ar 3,5 – 4,1
5 25 25 1,0 mm CuSi3-A Ar 4,0 – 4,6
6 26 26 1,0 mm CuSi3-A Ar 4,5 – 5,1
7 27 27 1,0 mm CuSi3-A Ar 5,0 – 5,5
8 28 28 1,0 mm CuSi3-A Ar 5,5 – 6,0
9 29 29 1,0 mm CuSi3-A Ar 6,0 – 6,5
10 30 30 1,0 mm CuSi3-A Ar 6,4 – 7,0
11 31 31 1,0 mm CuSi3-A Ar 6,9 – 7,6
12 32 32 1,0 mm CuSi3-A Ar 7,4 – 8,1
3.3.4 Adjustments, display and weld data
Display for welding current and welding material thickness. Changing can be made using the
button behind the display. There is a percentage display (eg. gas consistency) and seconds
display (see timer). The relative length of arc will be displayed when adjusted. Otherwise the
predicted current value is displayed (not in 2-MIG).
Process Manager™ for setting all welding parameters.
The display for wire feed speed, welding voltage or material group. This can be switched using
the button under the display (wire feed speed/length of arc). The voltage can be adjusted
in the normal and 1-MIG position (wire feed range/the length of arc). During pulse welding
the voltage is determined by the wire feed speed while the length of arc affects some other
parameters.
12
Kempac
t P
ulse 3000, Kempac
tC
ool 10 / © Kemppi O
y / 1136