Kemppi Kempact Pulse 3000 - Manual (Page 6)

EN
2.4 DISTRIBUTION NETWORK
All regular electrical devices without special circuits generate harmonic currents into
distribution network. High rates of harmonic current may cause losses and disturbance to
some equipment.
Kempact Pulse 3000:
WARNING: This equipment does not comply with IEC 61000-3-12. If it is connected to a public
low voltage system, it is the responsibility of the installer or user of the equipment to ensure,
by consultation with the distribution network operator if necessary, that the equipment may
be connected.
2.5 CONNECTION TO THE MAINS SUPPLY
The Kempact Pulse 3000 is delivered with a five metre mains cable without a plug. Installation
of the plug should be carried out only by a competent electrician. For fuse and cable sizes, see
the technical data in the end of this document.
2.6 GROUND CABLE
Fasten the earth clamp of the return current cable carefully, preferably direct onto the piece to
be welded. The contact surface of the earth clamp should always be as large as possible.
Clean the fastening surface of paint and rust. Use at least two 35 mm² cables. Thinner cross
sectional areas may cause the connectors to overheat.
2.7 DURATORQUE™ 400, 4 WHEEL WIRE FEED MECHANISM
Wire guide tubes
Ss, Al, Fe,
Mc, Fc ø 0.6 – 1.6 mm ø 2.5/64 mm,
W000762,
silver, plastic ø 2.5/33 mm,
W000956,
silver, plastic ø 2.0 mm,
W000624,
plastic
ø 1.6 – 2.4 mm ø 3.5/64 mm,
W001430,
silver, plastic ø 3.5/33 mm,
W001431,
silver, plastic ø 3.5 mm,
W001389,
plastic
Fe, Mc, Fc ø 0.6 – 0.8 mm ø 1.0/67 mm,
W001432,
white, steel ø 2.0/33 mm,
W001435,
orange, steel ø 2.0 mm,
W000624,
plastic
ø 0.9 – 1.6 mm ø 2.0/64 mm,
W001433,
orange, steel ø 3.5 mm,
W001389,
plastic
ø 1.6 – 2.4 mm ø 4.0/63 mm,
W001434,
blue, steel ø 4.0/33 mm,
W001436,
blue, steel ø 3.5 mm,
W001391,
brass
24.8.2005 12:55
2.
1.
4
Kempac
t P
ulse 3000, Kempac
tC
ool 10 / © Kemppi O
y / 1136