Datalogic Scanning POWERSCAN 7000 - Manual (Page 19)

Product Reference Guide 2-1
Chapter 2
Terminal Interfaces
Terminal ID
If your interface is not a standard PC AT, refer to Supported Terminals on
page 2-2 , and locate the Terminal ID number for your PC. Scan the Ter-
minal ID bar code below, then scan the numeric bar code(s) on the Pro-
gramming Chart on page B-5 of this manual to program the Imager for
your terminal ID. Scan Save to save your selection.
NOTE
Use this section to configure interface features
for imager models using RS-232 and USB inter-
faces.
For Imager models using UKBW interfaces, do
not use this section but refer to the UKBW Con-
nectivity Guide available for download from the
website listed on the back over of this manual.
In most cases and mainly in Concurrent Aiming
mode an external power supply is required.