Jetway Computer NC93 User Manual
Page 31
26
(default). Full-duplex means that you can transmit and send information simultaneously.
Half-duplex is the transmission of data in both directions, but only one direction at a time.
Onboard Parallel Port
The optional settings are: Disabled, 378/IRQ7, 278/IRQ5 and 3BC/IRQ7.
Parallel Port Mode
SPP : Standard Parallel Port
EPP : Enhanced Parallel Port
ECP : Enhanced Com Port
SPP/EPP/ECP/ECP+EPP
To operate the onboard parallel port as Standard Parallel Port only, choose “SPP.” To operate
the onboard parallel port in the EPP modes simultaneously, choose “EPP.” By choosing “ECP”,
the onboard parallel port will operate in ECP mode only. Choosing “ECP+EPP” will allow the
onboard parallel port to support both the ECP and EPP modes simultaneously. The ECP mode
has to use the DMA channel, so choose the onboard parallel port with the ECP feature. After
selecting it, the following message will appear: “ECP Mode Use DMA” at this time, the user can
choose between DMA channels 3 to 1.
Watchdog Timer Select
This item is used to activate the watchdog function. The optional settings are: Enabled; Disabled.
When set it as Enabled user can choose configuration figures in sub items.
Watchdog Timer Value
This item is only activated when Watchdog Timer Select is set as Enabled and users can set a
value from the range of 0~255
Watchdog Timer Unit
This item is only activated when Watchdog Timer Select is set as Enabled and the optional units
are: Sec. and Min..