Jetway Computer NC93 - Manual (Page 28)

23
Init Display First
This item allows you to decide to whether activate PCI Slot or Onchip VGA first. The
settings are: PCI Slot, Onchip VGA.
3-7-1 Onboard IDE Function
Phoenix – AwardBIOS CMOS Setup Utility
Onboard IDE Function
Item Help
OnChip IDE Channel Enabled
IDE Channel Master PIO Auto
IDE Channel Slave PIO Auto
IDE Channel Master UDMA Auto
IDE Channel Slave UDMA Auto
IDE DMA Transfer Access Enabled
IDE HDD Block Mode Enabled
*SATA Port Speed Settings Disabled
Menu Level >>
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
IDE Channel Master/Slave PIO
The two IDE PIO (Programmed Input/Output) fields let you set a PIO mode (0-2) for each of the two
IDE devices that the onboard IDE interface supports. Modes 0 through 2 provide successively
increased performance. In Auto mode, the system automatically determines the best mode for each
device. The settings are: Auto, Mode 0, Mode 1, Mode 2, Mode 3, Mode 4.
IDE Channel Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the
operating environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus
master driver). If your hard drive and your system software both support Ultra DMA/33 and
Ultra DMA/66, select Auto to enable BIOS support. The settings are: Auto, Disabled.
IDE DMA transfer access
The integrated peripheral controller contains an IDE interface with support for one IDE channels.
Select Enabled to activate each channel separately. The settings are: Enabled and Disabled.