Ivoclar Vivadent IvoBase Injector v.2 - Manual (Page 11)

4.1 Unpacking and checking the contents
The packaging provides the following advantages:
– Reusable packaging
– Closing mechanism with integrated transportation grips
– Ideal protection by Styrofoam inserts
– Easy handling during unpacking
– The packaging may be used in several ways (modules).
Remove the injector from the packaging and place it on a suitable
table. Please observe the instructions on the outer packaging.
Please keep in mind
that the IvoBase
Injector is very heavy.
It should always be
lifted and carried by
at least two people
(see image).
The IvoBase Injector is equipped with a special recessed grip at the
back and can conveniently be held at the operating panel at the
front.
Check the delivery for completeness (see delivery form in Chapter 9)
and transportation damage. If parts are damaged or missing, con-
tact your local Ivoclar Vivadent Service Centre.
Packing and shipping
The packaging may be discarded with the regular house-
hold refuse. However, we recommend keeping the origi-
nal packaging for future service and transportation
purposes.
The packaging permits simple and safe shipping. Simply
use the corresponding plastic inserts and fold the side
flaps.
11
4. Installation and Initial Start-Up
4.2 Selecting the location
Place the injector on a flat table on the rubber feet. Make sure that
the injector is not placed in the immediate vicinity of heaters or
other sources of heat. Make sure that air may properly circulate
between the wall and the injector.
Also ensure that there is enough space between the injector and
the user, as the injector releases heat during the opening of the
safety door.
The injector should neither be placed nor operated in areas
where there is an explosion hazard.
4.3 Removing the transport protection
Once the injector has been set up, the transport protection
(adhesive tape) at the safety door and the waste water container
can be removed.
3 2 1 3 2 1
3 2 1