Ivoclar Vivadent VivaSens - Manual (Page 2)

Application
VivaSens Free Stand
® Single Dose is applied by professional
dental personnel, using the pre-mounted and coated brush pro-
vided. Do not use one single dose for more than one patient!
Step by step application procedure
1.a Free Stand ® Single Dose
– Remove the foil lid.
– Remove the white applicator brush from its chamber and
dip into the chamber containing the VivaSens liquid.
– Twirl the applicator around thoroughly in order to mix the
liquid with the ingredients contained on the applicator
brush.
1.b Bottle
– Squeeze 3 drops of VivaSens onto a mixing block.
– Mix the liquid well with one of the pre-coated
applicator brushes (Always use exactly 3 drops per brush)
2. Clean all tooth surfaces thoroughly.
3. Dry the tooth surfaces with cotton pellets or a gentle
stream of air.
4. Apply VivaSens to the areas of the teeth affected by hyper-
sensitivity, using the disposable brush provided. Gently rub
the liquid into the teeth for at least
10 seconds, avoiding contact with the gingiva.
5. Evenly disperse the liquid and dry by gently blowing air on
the treated surfaces for 10 seconds.
Patient instruction
Advise patients not to rinse, eat, drink or brush their teeth for at
least 30 minutes following treatment.
Tip
Repeat the application if sensitivity recurs or persists.
Warning
– VivaSens liquid is an irritant. The coating on the applicator
brush is corrosive. Contact with the skin, mucous membra-
nes and eyes should be avoided.
– If contact with the eyes should occur, rinse immediately with
water and consult a doctor/ophthalmologist.
If the product comes into contact with the skin, wash
thoroughly with soap and water.
– Repeated skin contact may cause sensitivity to
methacrylates.
– Standard medical gloves do not offer protection from
sensitization to methacrylates.
– Easily flammable. VivaSens contains ethanol and must be
kept away from sources of ignition.
Special note
Operators can eliminate the risk of cross-contamination
by using VivaSens in the Single-Dose vessel for just one
patient. The applicator is for single use only and cannot be steri-
lized.
Storage
– Shelf-life: see expiry date on the Single Dose
– Do not use material after the indicated date of expiration
– Storage temperature: 2–28°C (36–82°F)
Keep the material out of the reach of children!
For dental use only!
Date information prepared: 04/2010, Rev. 1
Manufacturer
Ivoclar Vivadent AG, FL-9494 Schaan/Liechtenstein
The material has been developed solely for use in dentistry. Processing should
be carried out strictly according to the Instructions for Use. Liability cannot be
accepted for damages resulting from failure to observe the Instructions or the
stipulated area of application. The user is responsible for testing the material for
its suitability and use for any purpose not explicitly stated in the Instructions.
Descriptions and data constitute no warranty of attributes and are not binding.