Ivoclar Vivadent EP 600 Combi - Manual (Page 15)

15
4.1 Unpacking and
checking the contents
The new packaging provides the
following advantages:
– Reusable packaging
– Closing mechanism with inte-
grated transportation grips
– Ideal protection by Styrofoam
inserts
– Easy handling / optimum
unpacking
– The packaging may be used
in several ways (modules)
Check the delivery for complete-
ness (see delivery form in
Chapter 9) and transportation
damage. If parts are damaged
or missing, contact your local
Ivoclar Vivadent Service Center.
Remove the furnace components
from their packaging and place
the unit on a suitable table.
Please observe the instructions
on the outer packaging.
There are no special transpor-
tation grips on the furnace.
Support the bottom of the
furnace to carry it.
Packing and shipping of
individual components
The packaging of the
EP600 Combi permits simple
and safe shipping of individual
components. Simply use the two
corresponding inserts. Fold the
side flaps (2) and combine the
two packaging parts by means
of the transportation flaps.
The packaging may be discarded
with the regular household
refuse.
Important information
We recommend
keeping the original
packaging for future
transportation purposes. The
unit has been subjected to
extensive checks by the manu-
facturer. It may therefore exhibit
slight signs of testing (hairline
cracks, slight discoloration).
4.2 Selecting the location
Place the furnace on a flat table
using the rubber feet. Make sure
that the furnace is not placed in
the immediate vicinity of heaters
or other sources of heat.
Furthermore, protect the furnace
from direct sunlight. Make sure
that air may properly circulate
between the wall and the
furnace.
Also ensure that there is enough
space between the furnace and
the user, as the furnace releases
heat during the opening of the
furnace head.
The furnace should neither be
placed nor operated in areas
where there is an explosion
hazard.
4.3 Assembly and initial
start-up
Make sure the voltage indicated
on the rating plate complies
with the local power supply. If
this is not the case, the furnace
must not be connected.
4. Installation and Initial Start-Up