IHSE USA 461 Series DVXi/ET KVM Extender - Manual (Page 33)

SERVICE SETUP
33
4.1 Setup at the Local Unit
After unscrewing and opening the upper shell, please place the device in this orientation: with
the CATx/fiber connectors to the right and the electrical connectors to the left.
The main PCB then will look like this:
Use the diagram to locate jumpers.
DDC
You can select, whether the DDC is taken from internal DDC table or from local monitor or
the DDC information could be downloaded from remote monitor and stored into internal
table.
DDC JP1 JP2
1 Loading the DDC Information from the
Remote Monitor into the internal DDC
Table (see also below) (default)
2 From internal Table
3 From local Monitor
4 Reset DDC Table to factory values