IHSE USA 461 Series DVXi/ET KVM Extender - Manual (Page 32)

DVXI/ET-XX KVM-EXTENDER
32
4. Service Setup
For most applications, you shouldn't need not to make any adjustments to set up your
DVXi/ET KVM -Extender. Under some special circumstances it could be necessary to setup
configuration specials.
For some applications, you may need to open the Local Unit and/or the Remote Unit.
Unscrew the Philips-type screws at both sides at the bottom of the device. Unscrew the UNC
type screws at both sides of the monitor connectors. Carefully displace the lower and upper
shells of the case.
The diagnostic LED ‘Video OK’ is located at the local unit between the both DVI connectors
The diagnostic LED ‘Video OK’ is located near to the CATx- /fiber connectors
Fastening
screw on the
bottom of the
device Fastening
screw on the
bottom of the
device
Diagnostic LED
Video OK
Diagnostic LED
Link Status
(CATx)
Diagnostic LED
Link Status
(Fiber)