IBEA IBT-500 Series - Manual (Page 29)

Minitransporter IBT-500R / H / DH/ DHZ Pag. 29
HOW TO STOP
1. Put the throttle lever on low speed (L) (fig. 4).
2. Release the deadmanʼs control clutch lever slowly (fig. 11).
The body of the unit can lift off the ground on a steep slope.
Please exercise precaution against this possibility.
To stop the unit just turn the switch to “Stop” position (fig.5).
Finally, close the fuel cock (fig. 12).
Never leave the unit in a place where untrained people could start it.
Store the machine in an attended place and disconnect the spark plug wire to avoid accidental
starting.
HYDRAULIC DUMPER BED DISCHARGE
DUMPER BED DISCHARGE
MANUAL DUMPING
EXTENSIBLE BED
The loading bed of your unit is equipped with extendible side panels which will allow you to match the
bed dimensions with your transport need.
The side panels are individually extensible.
Just loosen the stop knobs on the lower side of the bed and extract the panels as necessary (fig. 13).
In order to balance the load applied, it is always advisable to maintain the same left and right panel over-
hang, so turning over of machine can be avoided.
It will also be possible to raise round bars loosening the 6 mm stop bolts on the outside of the panels un-
der the bars (fig. 14).
Lifting (fig. 15)
Pull the dump lever up. This will release the bed lock and raise the bed.
Lowering (fig. 16)
When the bed is lowered, the locking mechanism operates, locking the bed. To check that the bed is
securely locked, try to lift it without pulling up the dump lever.
Please be aware that if the bed lock is released on a steep slope when a load is concentrated in
the front of the bed, the load can suddenly dump itself.
For safety reasons, always drive the machine to a level surface before dumping the bed content.
In order to discharge the content of dumper bed, proceed according to following instructions.
1. Lower lever 1 (fig. 17).
2. Take lever 1 off its seat and insert it onto support 2 (fig. 17).
3. Rotate lever anticlockwise and raise it to dump the load (fig. 18).
4. To lower the dumper bed, just pull the lever down and secure the bed in operating position.
In order to discharge the content of hydraulic dumper bed, proceed according to following instructions.
1. From operating position, move lever 1 backward to raise the bed (fig. 19).
2. To lower the hydraulic dumper bed, just push the lever forward and secure the bed in operating posi-
tion (fig. 20).
IBT500 REIMPAGINATO.indd 29 30/06/14 11.00