DMP Electronics XR6 - Manual (Page 15)

11
Security Command User Menu
Many of the features of your system have been put into a User Menu
you can access from any Security Command keypad. The menu
requires you to enter your user code and then only shows those
functions to which you have access.
To access the User Menu:
1. Press the COMMAND key until MENU? NO YES displays.
2. Select YES. The keypad displays ENTER CODE: –. Enter your
user code. You can now scroll down through the list of system
features available to your authority level. The following pages detail
each User Menu item and instruct you on when and how to use them
properly. The User Code Level reflects the authority level required.
User Checkin
User Code Level: Master or Standard (Home/Away arming only)
Function: This feature allows you to monitor the arrival of employees
or latchkey children by having a special Checkin Report sent to your
numeric pager. Your system must be programmed for Home/Away
arming and the Pager Direct™ option.
Sending a Checkin Report:
1. After disarming the system, access the User Menu. (Or press the
COMMAND + 7 keys and enter your code to send a Checkin
Report. This feature works on 32-character keypads only.)
2. At the USER CHECKIN? display, press any SELECT key. The
keypad displays USER CHECKIN: 11 ( 11 = user number).
3. The panel sends the Checkin Report containing your account
number and user number to the pager.
Sensor Reset
User Code Level: Master or Standard
Function: Resets smoke or glassbreak detectors. Also clears Fire/
Supervisory alarm and trouble keypad displays.
Sensor Reset is used to reset smoke and glassbreak detectors after
they have been tripped. Once these detectors have tripped, they
must be reset before they can detect any additional alarm conditions.
When Sensor Reset is selected, power to the detectors is temporarily
removed by the system allowing them to reset.
Make sure all smoke is cleared from around the area of the smoke
detectors before performing a Sensor Reset to prevent the alarm
from occurring again.
Resetting the Sensors
1. Access the User Menu.
2. When SENSOR RESET? is displayed, press any SELECT key.
The keypad displays SENSORS OFF for five seconds followed
by SENSORS ON.
3. The keypad returns to the status display.
Enter your security code to reset sensors
While your system is disarmed, you can just enter your security code
and press COMMAND to reset the sensors.
This also activates the door strike if your system has an Easy Entry™
keypad.
User Menu