Hypertherm MAX200 Service Manual - Manual (Page 39)

2-4 MAX200 Service Manual
1-99
SPECIFICATIONS
Gas Requirements:
Gas Type/Quality..................................................Air (compressed)/clean, dry, oil-free
Oxygen (O
2
)/99.5% (liquid)
Nitrogen (N
2
)/99.995% (liquid)
Carbon Dioxide (CO
2
)/99.5% (compressed or liquid)
Argon/Hydrogen (H35 = 35% Hydrogen/65% Argon)
Plasma Gases .....................................................Air, O
2
, N
2
, H35
Shield Gases .......................................................Air, CO
2
, N
2
Plasma Gas Flow ................................................66 scfh (Air), 60 scfh (N
2
), 70 scfh (H35), 72 scfh (O
2
)
Shield Gas Flow ...................................................220 scfh (CO
2
), 280 scfh (Air), 290 scfh (N
2
)
Plasma Gas Inlet Pressure .................................90/120 psi (6.2/8.3 bar) (flowing)
Shield Gas Inlet Pressure ...................................90 psi (6.2 bar) (flowing)
Plasma Gas Pressure (Test/Run).........................See Cut Charts in Operation section of IM87 (#800870)
or IM98 (#800980)
Shield Gas Pressure ...........................................70 psi (4.8 bar)
MAX200 CE Power Supplies
The specifications specific to the 400V CE power supplies (073200 and 073213) are listed below. These CE power
supplies conform to all other CE power supply specifications as listed above. Refer to Appendix A for EMC
requirements, power cable connections, and parts information specific to the MAX200 CE power supplies.
Input Power (Input Voltage (U
1
) x Input Current (I
1
)):
# 073200 (without THC) .......................................400 VAC, 3Ø, 50 Hz, 56 amps
# 073213 (with THC) ............................................400 VAC, 3Ø, 50 Hz, 56 amps
Dimensions:
Height ...................................................................40-3/4" (104 cm) w/o casters
48-1/4" (122 cm) w/casters
Weight ..................................................................800 pounds (363 kg)