Maintenance -12, Drive mechanism -12, Inspect nozzle -12 – Hypertherm LH2100 User Manual

Page 39: Inspect lens -12, Maintenance

OPERATION

4-12

LH2125/LH2100 Laser Head Instruction Manual

Maintenance

Drive mechanism

Note: Lubricate drive screws with Hypertherm silicone grease (027012) every 6 months or as

needed.

Inspect nozzle

– Inspect nozzle orifice for damage.
– Inspect for excessive beam hole (double the kerf width or greater) through baffle of Hypertherm FAST Laser

nozzles. The beam hole diameter should be approximately equal to the kerf width.

– Inspect for spatter on nozzle.
– Replace nozzle if damaged

Inspect lens

– Inspect for scratches and foreign material on lens.
– Inspection using cross-polarization may be necessary to reveal damage to the substrate. Cross-polarization is

achieved by arranging two polarized sheets so that you can not see through them. Hold the two sheets
together. If you can see through them, they are parallel. Turn one sheet 90

and they will become opaque (cross-

polarized).

– Hold one sheet above the lens and one below. Damage to the substrate of the lens will become visible.
– Replace lens if damaged.

This manual is related to the following products:

LH2125