Hypertherm LH2100 - Manual (Page 23)

Connect cables
Interface box (CHS) 15-pin cable to controller
Amplifier module to interface box (CHS)
1
INSTALLATION
3-8 LH2125/LH2100 Laser Head Instruction Manual
Capacitive height sensor (CHS) interface box installation
The amplifier module will be mounted to the laser head if the capacitive height sensing option was ordered. Choose a
suitable location for the CHS interface box.
Controller cable connector information (15 pin D-Sub)
Pin-outs (Output To Controller)
Note: Outputs are dry-contact relay outputs.
Pin Wire
Number Color Description
1 Blue Not used
2 Purple Not used
3 Brown Over-range +
4 Grey Over-range -
5 Yellow Tip-touch +
6 Green Tip-touch -
7 White Distance signal +
8 Orange Distance signal -
9 Red + Volt input (9-36 VDC)
10 Black - Volt input
11-14 Not used
15 Shield Electromagnetic Protection (earth ground)
Power indicator
Over-range indicator
Under-range indicator
(not shown)