Delta 36-465 - Manual (Page 15)

15
Fig. 24
Fig. 25
Fig. 26
ASSEMBLING
BLADE GUARD AND
SPLITTER ASSEMBLY
DISCONNECT MACHINE FROM POWER
SOURCE.
1. Fasten the rear splitter mounting bracket (A) Fig. 24,
to the rear trunnion using the two 1/4-20 x 3/4" hex head
bolts (B) and flat washers. Do not completely tighten the
two bolts (B) at this time.
2. Raise saw arbor to its highest position. With
wrenches supplied, remove the saw blade from the saw.
Refer to section “CHANGING THE SAW BLADE” of this
manual.
3. Remove bolt and large washer (C) Fig. 25, from the
inside splitter mounting bracket.
4. Use a straight edge (E) to check to see if the top and
bottom of the inside splitter bracket (D) Fig. 26 is aligned
with the inner arbor flange (F).
B
A
C
D
F
ASSEMBLING AND ALIGNING
BLADE GUARD AND SPLITTER ASSEMBLY
E