Assembling motor and motor mounting plate to saw – Delta 36-465 User Manual
Page 12
12
Fig. 14
Fig. 13
ASSEMBLING MOTOR
AND MOTOR MOUNTING PLATE TO
SAW
DISCONNECT MACHINE FROM POWER
SOURCE.
1.
Locate the two pins (X) Fig. 12 that insert into holes
(D) in each side of bracket (B). The pins (X) are spring (Y)
loaded from factory.
2.
Position motor and motor mounting plate (A) Fig. 13
below bracket (B) to allow bracket arm to slide through
large opening in motor mounting plate (A).
3.
Depress pins (C) Fig. 13, on both sides of bracket
(B) and rotate motor mounting plate (A) until pins (C) are
engaged in holes (D) Fig. 12, of motor mounting plate
(A).
4.
Fig. 14 illustrates the motor and motor mounting
plate assembled to the rear of the saw.
B
D
A
C
B
C
A
Fig. 12
X
Y
X