Guralp Systems CMG-1T - Manual (Page 30)

CMG-1T Ocean Bottom Seismometer Operator’s
Guide
Section 8, Page 2 September, 1999,
Issue C
AFTER initial levelling. This command tries to reduce the
accuracy of levelling better than
±
0.3 degrees. It can only
be issued after the LEVEL command.
STATUS COMMANDS
HELP
- displays all commands and parameters that are available.
SENSOR
STATUS
- reports the digitized mass position outputs of the sensors.
BOWL
STATUS
- reports the tilt and rotate orientation of the bowl and the X
and Y inclinometer readings.
SYSTEM SERIAL PORT
The baud rate of the serial line is 19,200 Baud 8 data bits, 1 stop bit, no parity
and no handshake.