Denon DN-H800 - Manual (Page 20)

20
ENGLISH
LISTENING TO RADIO PROGRAMS
1. Using the auto preset memory function
This function automatically stores the FM stations which can
be received in the area in which the set is being used in the
preset memory. Use this function so that the RDS functions
can be used more effectively. Also note that the channel
memories can be changed at will even after the preset
stations have been stored with this function.
Operation
1. Connect the FM antenna and set it so that FM stations can
be received.
2. Press the POWER button to turn on the power while
holding in the MEMORY and SHIFT/PTY button.
3. Searching begins automatically and stations are stored in
the preset memory in order, beginning from channel A1.
(The operation automatically stops once 30 stations have
been set in the memory).
2. Storing new stations at the preset channels
The reception frequency, RDS service information. Tuning
mode and input characters can be stored at the different
channel memories.
When this operation is performed, the station already stored
in that channel memory using the auto preset memory
function is cleared.
Operation
1. Press the MEMORY button. (The “MEMO” indicator flash.)
2. Use the SHIFT/PTY button to select the block, A to F.
3. Use PRESET buttons (1 to 5) to select the channel at which
the station is to be stored.
4. Press the MEMORY button while the “MEMO” indicator is
flashing.
3. Recalling preset channels
Use the following operation to recall preset channels:
Operation
1. Use the SHIFT/PTY button to select the block, A to F.
2. Use PRESET buttons (1 to 5) to select the channel at which
to store the station.
Using the Various Functions
4. Inputting characters
Some characters can be input (up to 8 characters).
The input characters can be stored at the preset channels.
Operation
1. Press the SEARCH/CHA button four times.
(The cursor flashes at the first place.)
•
Flashes
•
Flashes
2. Use the TUNING buttons to select the character for the first
place.
(The selected character flashes.)
•
Flashes
3. Press the SHIFT/PTY button to move the cursor the next
place.
(The cursor flashes at the second place.)
•
Flashes
4. Repeat steps 2 and 3 above to input up to 8 characters.
5. Press the MEMORY button twice within 5 seconds of entry
completion. The input characters can be stored in the
memory.
To keep the input characters, be sure to store them in a
channel memory.
6. Clearing characters
1. Recall the character you want to clear.
2. Press the SEARCH/CHA button 4 times until the
character at the first place flashes.
3. Then press the SHIFT/PTY button for at least 4 seconds.
The current character will then be cleared.
Using the RDS Functions (for FM only)
1. RDS Search
Use this to automatically search and stop at station offering
RDS services.
Operation
1. Press the SEARCH/CHA button once.
ª
Flashes
ª
Flashes
2. Press the TUNING button to start a search of the preset
frequencies.
Flashes