beautypg.com

Denon DN-H800 User Manual

Page 13

background image

13

ENGLISH

Installing the AM loop antenna

Tune in an AM station and set the antenna in a position as far

from the system as possible in which distortion and noise is

minimum. In some cases it is best to invert the polarities.

AM broadcasts cannot be received well if the loop antenna is not

connected or if it is set close to metal objects.

Assembling the AM loop antenna

Assemble the included AM loop antenna as shown in the

diagram.

q

Remove the clamp.

w

Insert the AM loop antenna into the antenna stand.

Connecting the AM loop antenna

Connect the included AM loop antenna to the antenna terminals

as shown in the diagram.

Installing an AM outdoor antenna

Connect the signal wire from the AM outdoor antenna to the

antenna terminal. Be sure to ground the antenna and connect

the ground wire to the GND terminal. Also be sure to connect

the included AM loop antenna.

Connecting an FM outdoor antenna

If good reception cannot be achieved with the included FM

antenna, use an FM outdoor antenna. Connect an F-shaped

connector to the coaxial cable and connect the antenna to the

FM COAX (75

/ohms) terminal.

Selecting a place for the FM outdoor antenna

• Set the antenna so that it is pointing towards the broadcast

station’s transmitting antenna. Behind buildings or mountains,

set the antenna in the position at which reception is best, and

also try changing the direction of the antenna.

• Do not install the antenna under power lines.

Doing so is extremely dangerous, as the power line could

touch the antenna.

• Install the antenna away from roads or train tracks to avoid

noise from cars or trains.

• Do not install the antenna too high, as it may be hit by

lightning.

Antenna stand

Loop antenna terminals

AM outdoor antenna

Approx. 12 meters

Ground

8 meters
or greater

AM loop antenna

2

Connecting the included antennas

AM loop antenna

q

Loosen the
terminal knobs.

w

Insert the antenna
wire.

e

Tighten the
terminal knobs.

Note to CATV system installer:

This reminder is provided to call the CATV system

installer’s attention to Article 820-40 of the NEC, which

provides guidelines for proper grounding and, in particular,

specifies that the cable ground shall be connected to the

grounding system of the building, as close to the point of

cable entry as practical.

CONNECTIONS

* Place the antenna 10 cm away from the set.

Direction of
broadcasting station

FM antenna

75

/ohms

coaxial cable