Gullco PK-500-LG-x - Manual (Page 19)

15
TORCH SLIDE: The Torch Slide provides 2” or [50.8 mm] of motorized torch tip-to-work vertical
adjustment. Adjustment is achieved by using the Torch Slide Jog switch located on the Remote
Pendant.
TORCH PIVOT: Use the locking handle to adjust the angle of the welding torch to the pipe.
TORCH MOUNTING BRACKET: This adjustment bracket mounts the torch to the motorized
Torch Slide; it also serves as a manual vertical torch slide allowing movement through the use
of a locking handle.
TORCH LEAD/LAG ADJUSTMENT: The Torch Lead/Lag Adjustment assembly is attached to
the oscillator slide and is used to set the Lead/Lag angle of the welding torch. A range of 10°
positive to 10° negative is permitted by rotating the knurled knob.
LINEAR OSCILLATOR HEAD: This motorized slide is fully programmable (see page 19) and
provides torch positioning and linear oscillation movement of the welding torch.
WIRE FEEDER: This compact wire feed unit uses a pair of drive rolls (available in various sizes
and types to suit the customers’ requirements) to deliver the welding wire through the welding
torch.
UMBILICAL CLAMP: This clamp provides a strain relief for the umbilical and prevents
damage. to the electrical connections, welding power cable, and water & shielding gas hoses
and ground cable twist connector
General dimensions of the PIPE KAT
®
carriage