Gullco PK-500-LG-x - Manual (Page 15)

11
CARRIAGE
JOG
CARRIAGE WELD SPEED
TRIM OVERRIDE
WELDING VOLTAGE
CONTROL WIRE FEED
JOG
WIRE FEED SPEED
TRIM OVERRIDE
TORCH SLIDE
JOG
EMERGENCY
STOP
AUTO CYCLE STOP
PUSH BUTTON AUTO CYCLE START
PUSH BUTTON
RED & GREEN
L.E.D.s
OSCILLATION
WIDTH
ADJUSTMENT
OSCILLATOR
CENTER POSITION
ADJUSTMENT
WELD ENABLED/
DISABLED
REMOTE PENDANT
The Remote pendant is used in conjunction with the main control to provide adjustment
during setup, initiate the weld cycle, provide fine adjustment during welding, and to stop the
weld cycle.
During setup the pendant is used to provide the following:
Position the carriage to the welding start position
Adjust oscillator center position
Adjust torch height in relation to the pipe
Advance the wire towards and back from the pipe
Set welding voltage
During the welding operation the pendant can be used to provide the following fine adjustments:
Carriage
speed
Wire feed speed
The torch height in relation to the pipe (tip-to-work distance)
Oscillation center position
Oscillation width adjustment
Adjust welding voltage
The remote pendant is supplied with a 35ft communication cable that connects to the
right side panel of the PIPE KAT
®
Main Control. The functions of the Remote Pendant are
discussed in detail below.