Safety instructions – Gullco SAM CM-02-250 User Manual
Page 3

1
SAFETY INSTRUCTIONS
Although the Gullco "SAM
®
" carriage is manufactured for safe and dependable operation, it is
impossible to anticipate those combinations of circumstances, which could result in an accident. An
operator of this equipment is cautioned to always practice "Safety First" during each phase of
operation, setup and maintenance.
Read and understand this whole manual before operating or performing service of this equipment.
Become familiar with the machines operation, applications and limitations. Keep this manual in a
clean and readily available location.
This equipment is normally used to automate / semi-automate welding processes. These
processes usually have any combination of the following; bright and hot arcs, flying sparks, fumes,
ultraviolet and infrared radiated energy, hot work-pieces, compressed gases, etc.. The onus is on
the operator of this equipment to know, understand and follow all the safety precautions associated
with the process being used.
A careless operator invites troubles, and failure to follow safety practices may cause serious injury
or even death. Important safety precautions are given in the following:
Electrical Shock Prevention
¾ Do not use this equipment in damp or wet locations.
¾ Do not expose this equipment to rain.
¾ Never carry this equipment by the cables or pull the cables to disconnect from the
receptacle.
¾ Keep all cables from heat, oil and sharp edges.
¾ Inspect all cables periodically and replace if damaged.
¾ Inspect the security of all cables periodically and repair if loose.
¾ Disconnect the power cord when not in use.
¾ Disconnect the power cord positively to prevent electrical shock before repair and service
of the equipment.
Bodily Injury Prevention
¾ Do not wear loose clothing, jewellery and loose, long hair, which may get caught into
automatic systems or moving parts.
¾ Keep handles & lifting points dry, clean, free from oil & grease and in good repair.
¾ Do not operate this equipment if ill or drowsy from medication or fatigue.
¾ Do not lift this machine if equipped with heavy accessories or welding cables attached.
¾ Lift machine only with equipment of adequate lifting capacity.
¾ Never lift or suspend the machine over personnel.
¾ Always keep this equipment clean and in good working order.
¾ Report any unsafe condition for immediate correction.