Grip Factory Munich GF-9 - Manual (Page 8)

GF-9 Crane System Instruction Manual
Page: 7
3.
Further levelling of the tripod can be achieved by turning the leveller at the bottom of
each leg and observing the water level on the pan section. Attention: the maximum
levelling range is 30mm / 1inch (see below picture). When level, lock off the leveller to
avoid any unwanted movement and twisting.
Levelling the tripod Securing the leveller
4. Now the tripod is ready. Continue assembly as from § 3 page 3.
Attention:
When using the crane ensure that the tripod legs/feet cannot shift or move, for example
when panning the arm.
When the crane is at i
t’s maximum tilt angle, be it in the plus or minus range, it is
important, especially when using the 100cm / 3ft rear section, to stop the arm crashing into
the pan bearing with force. A hard collision can cause the crane to topple over.!
Maximum tilt on tripod Avoid forceful stops into the pan bearing
Max. 30 mm
1 inch