Grip Factory Munich GF-9 - Manual (Page 6)

GF-9 Crane System Instruction Manual
Page: 5
Connecting the rigging rod to extension arm
10. Connect the parallelogram rod (either 100cm or 150cm) to the middle section and the
angle adjuster and secure it with a safety pin at each end.
Tip:
The angle adjuster has an integrated leveller. By turning it, the vertical plate
on the angle adjuster can be set to a perfect right angle. Correct setting of the angle
adjuster enhances the crane’s balance.
Connecting the parallelogram rod
Securing the parallelogram rod Levelling the angle adjuster
The assembly procedure up to this point is the same in all versions.
To assist the set-up procedure and to reduce the risk of accidents it is recommended to
use set-up support stands or rostrums to support the crane arm during set-up and
breakdown.