Greenheck Waterwash (458292) - Manual (Page 11)

11 April 2005
®
HANGER BRACKET
ATTACH HANGING CLIP TO
HOOD STANDING SEAM WITH
THE SUPPLIED "C" CLAMPS
(OPTIONAL: DRILL AND BOLT A
1/4-20 SS BOLT THROUGH
THE CLIP AND HOOD STANDING
SEAM)
TOP VIEW
HOOD
TOP VIEW
SUPPLY PLENUM
2 CLIPS ARE NEEDED
3 CLIPS ARE NEEDED
FOR PLENUMS > 96"
FOR PLENUMS <= 96"
THE THIRD CLIP IS LOCATED
IN THE CENTER OF THE PLENUM
LENGTH
D
OPTION #1
ON THE END OF THE HOOD
HANGING CLIP COULD BE 23.5" FROM
END IF THERE IS A UTILITY CABINET
OPTION #1
OPTION #1
OPTION #2
UNI-STRUT SUPPLIED BY OTHERS
OPTIONAL
UTILITY
CABINET
OTHERS
11.5
23.5
Using the Supply Plenum Clip
1. Bolt the hanging clip to the supply
plenum - 2 clips are needed for plenums
less than 96 in. long and 3 for plenums
greater than 96 in. The third clip is
located in the center of the plenum
length. If there is a utility cabinet, the
hanging clip should be 23.5 in. from the
end to the hood.
2. Using the C-Clamps provided, clamp the
supply plenum hanging clip to the hood
standing seam. Option: Drill and bolt a
1/4-20 SS bolt through the clip and hood
standing seam.
INSTALLATION INSTRUCTIONS FOR EXTERNAL SUPPLY PLENUMS
USING THE SUPPLY PLENUM CLIP or UNI STRUT
HOOD STANDING SEAM
HANGING CLIP BOLTED TO PLENUM SHELL
HANGING CLIP
HOOD FRONT
"C" CLAMP
SUPPLY PLENUM SHELL
HANGING CLIP
OPTION #1
Supply Plenum Clip
Using the UNI-STRUT
1. The uni-strut (supplied by others)
that holds the hood up
cantilevers over the end of the
hood and is mounted to the
supply plenum hanger brackets.
P
END VIEW
THREADED ROD
HOOD
THREADED ROD
OPTION #3
THE HOOD AND IS MOUNTED TO THE ASP
HOOD UP CANTILEVERS OVER THE END OF
THE UNI-STRUT (U-CHANNEL) THAT HOLDS THE
HANGER BRACKETS
OPTION #2
OPTION #2 = UNI-STRUT
OPTION #3 = THREADED ROD
SUPPLIED BY OTHERS
ASP, FSP, VSP