Grandstream GXW410x User Manual - Manual (Page 15)

Grandstream Networks, Inc. GXW410x User Manual Page 15 of 32
Firmware Version 1.4.1.5 Last Updated: 5/2014
Syslog Level Select the GXW to report the log level. Default is NONE. The level is one of DEBUG,
INFO, WARNING or ERROR. Syslog messages are sent based on the following
events:
1. product model/version on boot up (INFO level)
2. NAT related info (INFO level)
3. sent or received SIP message (DEBUG level)
4. SIP message summary (INFO level)
5. inbound and outbound calls (INFO level)
6. registration status change (INFO level)
7. negotiated codec (INFO level)
8. Ethernet link up (INFO level)
9. SLIC chip exception (WARNING and ERROR levels)
10. memory exception (ERROR level)
The Syslog uses USER facility. In addition to standard Syslog payload, it contains the
following components: GS_LOG: [device MAC address][error code] error message
Example: May 19 02:40:38 192.168.1.14 GS_LOG: [00:0b:82:00:a1:be][000] Ethernet
link is up
Security
Download Configure Downloads the current configuration of the GXW410X
TABLE 7: NETWORKS DEFINITIONS
NETWORKS
Basic Settings
IP Address There are two modes to operate the GXW410x:
DHCP mode: all the field values for the Static IP mode are not used (even though
they are still saved in the Flash memory.) The GXW410x acquires its IP address from
the first DHCP server it discovers from the LAN it is connected.
Using the PPPoE feature: set the PPPoE account settings. The GXW410x will
establish a PPPoE session if any of the PPPoE fields is set.
Static IP mode: configure the IP address, Subnet Mask, Default Router IP address,
DNS Server 1 (primary), DNS Server 2 (secondary) fields.
DHCP hostname This option specifies the name of the client. This field is optional but may be required
by some Internet Service Providers. Default is blank.
DHCP domain This option specifies the domain name that client should use when resolving
hostnames via the Domain Name System. Default is blank.
DHCP vendor class ID Used by clients and servers to exchange vendor-specific information. Default is
Grandstream GXW410x.
PPPoE account ID PPPoE username. Necessary if ISP requires you to use a PPPoE (Point to Point
Protocol over Ethernet) connection.
PPPoE password PPPoE account password.
PPPoE Service Name This field is optional. If your ISP uses a service name for the PPPoE connection,
enter the service name here. Default is blank.
Preferred DNS server This field will let the user enter a preferred DNS server to be used instead of the one
acquired by the service provider.
Time Zone Controls how the date/time is displayed according to the specified time zone.
Allow DHCP Option 2 to
override
Time Zone
Settings
Default is No. If set to Yes, time zone settings will originate from the DHCP server.
Advanced Settings
Layer 3 QoS This field defines the layer 3 QoS parameter which can be the value used for IP
Precedence or Diff-Serv or MPLS.
Default value is 48. Its range lies from 0 to 63.