Grandstream GXW410x User Manual - Manual (Page 14)

Grandstream Networks, Inc. GXW410x User Manual Page 14 of 32
Firmware Version 1.4.1.5 Last Updated: 5/2014
TABLE 6: MAINTENANCE DEFINITIONS
MAINTENANCE
Web/Telnet access
Web Access Select HTTP or secure HTTPS protocol for Web Access
Web Port This option defines Web Port desired to use. This field is optional. Default is 80 for
HTTP and 443 for HTTPS.
End-User Password This contains the password to access the End-user Web Configuration Menu (Status
and Basic Settings). This field is case sensitive with a maximum length of 25
characters.
Admin Password Contains the password to access administrative settings other than Basic Settings and
Status Page.
Upgrade/Provisioning
Firmware Upgrade &
Provisioning
This radio button will enable GXW410x to download firmware or configuration file
through either TFTP or HTTP.
Via TFTP Server If selected, the GXW410x will attempt to retrieve new configuration file or new code
image from the specified TFTP server at boot time. It will make up to 5 attempts before
timeout and then it will start the boot process using the existing code image in the
Flash memory. If a TFTP server is configured and a new code image is retrieved, the
new downloaded image will be verified and then saved into the Flash memory.
Note: Please do NOT interrupt the TFTP upgrade process (especially the power
supply) as this will damage the device. Depending on the network environment this
process can take up to 25 or 30 minutes.
Via HTTP Server The URL for the HTTP server used for firmware upgrade and configuration via HTTP.
For example, ttp://provisioning.mycompany.com:6688/Grandstream/1.0.0.54
Here “:6688” is the specific TCP port that the HTTP server is listening at, it can be
omitted if using default port 80.
Note: If Auto Upgrade is set to No, GXW410x will only do HTTP download once at boot
up.
Firmware Server Path IP address or domain name of firmware server.
Config Server Path IP address or domain name of configuration server.
Firmware File Prefix Default is blank. If configured, GXW410x will request firmware file with the prefix. This
setting is useful for ITSPs. End user should keep it blank.
Firmware File Postfix Default is blank. End user should keep it blank.
Config File Prefix Default is blank. End user should keep it blank.
Config File Postfix Default is blank. End user should keep it blank.
Allow DHCP Option 66 to
override server Default value is No. If set to Yes, configuration file will originate from the DHCP server.
Automatic Upgrade Choose Yes to enable automatic upgrade and provisioning. In “Check for new
firmware every” field, enter the number of minutes to enable GXW410x to check the
server for firmware upgrade or configuration. When set to No, GXW410x will only do
upgrade once at boot up. Other options are:
“ Always check for New Firmware.”
“ Check New Firmware only when F/W pre/suffix changes”
“ Always skip the Firmware check”
Syslog Setup
Syslog Server The IP address or URL of System log server. This feature is especially useful for ITSP
(Internet Telephone Service Provider)