Grandstream DP715 User Manual - Manual (Page 47)

Firmware version 1.0.0.33 DP715/DP710 User Manual Page 45 of 56
Cone, Restricted Cone, or a Port-Restricted Cone, the DP715 will use its mapped public
IP address and port in all of its SIP and SDP messages.
If the NAT Traversal field is set to “Yes” with no specified STUN server, the DP715 will
periodically (every 20 seconds or so) send a blank UDP packet (with no payload data) to
the SIP server to keep the “hole” on the NAT open.
Advance Configuration
DNS Mode One from the 3 modes are available for “DNS Mode” configuration:
-A Record (for resolving IP Address of target according to domain name)
-SRV (DNS SRV resource records indicates how to find services for various protocols)
-NAPTR/SRV (Naming Authority Pointer according to RFC 2915)
One mode can be chosen for the client to look up server.
The default value is “A Record”
Tel URI The default setting is “Disabled”. If the phone has an assigned PSTN
Number, this field should be set to “User=Phone” then a
“User=Phone” parameter will be attached to the “From header” in the SIPrequest to
indicate the E.164 number. If server supports TEL URI format, then this option needs to
be selected.
SIP Registration Controls whether the DP715 needs to send REGISTER messages to the proxy server.
The default setting is Yes.
Unregister on Reboot Default is No. If set to Yes, the SIP user’s registration information will be cleared on
reboot.
Outgoing Call without
Registration Default is No. If set to “Yes,” user can place outgoing calls even when not registered (if
allowed by Internet Telephone Service Provider) but is unable to receive incoming calls.
Register Expiration This parameter allows the user to specify the time frequency (in minutes) the DP715
refreshes its registration with the specified registrar. The default interval is 60 minutes (or
1 hour). The maximum interval is 65535 minutes (about 45 days).
Reregister before
Expiration This parameter allows the user to specify the reregisteration time before expiration.
SIP Registration Failure
Retry Wait Time Retry registration if the process failed. Default is 20 seconds.
Local SIP port Defines the local SIP port the DP715 will listen and transmit. Default is 5060 for profile 1 &
6060 for profile 2.
Local RTP port Defines the local RTP port the DP715 will listen and transmit. It is the base RTP port for
channel 0. When configured,
channel 0 uses this port _value for RTP. Default is 5004 for profile 1 & 6004 for profile 2.
Use Random Port Default is No. This parameter forces the random generation of both the local SIP and RTP
ports when set to Yes. This is usually necessary when multiple DP715 are behind the
same NAT.
Refer-To Use Target
Contact Default is No. If set to YES, then for Attended Transfer, the “Refer-To” header uses the
transferred target’s Contact header information.
Transfer on Conference
Hang up Default is No. In which case if the conference originator hangs up the conference will be
terminated. When option YES is chosen, originator will transfer other parties to each other
so that B and C can choose to either continue the conversation or hang up.
Disable Bellcore Style 3-
Way Conference Default is No. you can make a Conference by pressing ‘Flash’ key. If set to Yes, you need
to dial *23 + second callee number.
Remove OBP from
Route Header Default is No. When option YES is chosen, the Out Bound Proxy will be removed from
Route header.
Support SIP Instance ID Default is Yes. If set to Yes, the contact header in REGISTER request will contain SIP
Instance ID as defined in IETF SIP Outbound draft.
Validate incoming SIP Default is No. If set to yes all incoming SIP messages will be strictly validated according to