Grandstream DP715 User Manual - Manual (Page 39)

Firmware version 1.0.0.33 DP715/DP710 User Manual Page 37 of 56
DP715 BASE STATION - CONFIGURATION GUIDE
CONFIGURING THE BASE STATION THROUGH VOICE PROMPTS
DHCP M ODE
Select voice menu option 01 to enable DP715 to use DHCP.
STATIC
IP M ODE
Select voice menu option 01 to enable DP715 to use STATIC IP mode, then use option 02, 03, 04, 05 to
set up IP address, Subnet Mask, Gateway and DNS server respectively.
Please refer to UNDERSTANDING DP715/710 VOICE PROMPT for more configuration detail.
F
IRMWARE S ERVER IP A DDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
C
ONFIGURATION S ERVER IP A DDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
U
PGRADE P ROTOCOL
Select voice menu option 15 to choose firmware and configuration upgrade protocol. User can choose
between TFTP and HTTP.
F
IRMWARE U PGRADE M ODE
Select voice menu option 17 to choose firmware upgrade mode among the following three options:
1) Always check, 2) check when pre/suffix changes, and 3) never upgrade.
CONFIGURING THE BASE STATION VIA WEB BROWSER
DP715 Base Station has an embedded Web server that will respond to HTTP GET/POST requests. It also
has embedded HTML pages that allow users to configure the DP715 through a web browser such as
Microsoft’s IE, AOL’s Netscape or Mozilla Firefox installed on Windows or Unix OS. (Macintosh OS is not
included).
Access the Web Configuration Menu
1. Find the IP address of the Base Station using voice prompt menu option 02.
2. Open a web browser, type in the IP address.You will see the login page of the device.
Once the HTTP request is entered and sent from a web browser, the user will see a login screen. There
are two default passwords for the login page:
User Level: Password: Web pages allowed:
End User Level 123 Only Status and Basic Settings
Administrator Level admin Browse all pages