Grandstream GXP21xx XML Application Guide - Manual (Page 8)

FIRMWARE VERSION 1.0.4.23 GXP21xx XML APPLICATION GUIDE Page 8 of 36
• Examples:
http://192.168.40.10/XMLapp/welcome.xml
mycompany.com:8080/surveyapp.xml
https://service.mycompany.com/XMLapp/reservation.xml
https://admin:[email protected]/GXP2120/API.xml
Note:
• If "http://" is not specified in the Server Path, the phone will use HTTP by default. Therefore, "http://" is
not necessary to be included in the path if HTTP is used.
• For HTTPS, users must specify "https://" in the Server Path. If username and password are required by
the HTTPS server, users could use "https://username:password@server_address/directory" to access.
• The content in [ ] is optional. If ":port" is not specified, by default port 80 will be used for HTTP and port
443 will be used for HTTPS.
The default value for Softkey Label is "XML Service". Users presses this softkey to launch the XML
application. Please make sure the label string does not exceed the softkey maximum length on each model.
After the above configuration, click on "Update" in web GUI->Settings->Advanced Settings page. The
GXP21xx will then display the XML Service softkey on LCD. Press the softkey with the configured label to
launch the application.
Users may also use config file to provision the XML Application Server Path and Softkey Label to the phone.
In this case, GXP21xx needs to be provisioned and rebooted. The corresponding P values are as below.
• P337: Server Path.
This is a string of up to 256 characters that should contain the path to the XML application file.
• P352: Softkey Label.
This is a string of up to 16 characters to display the softkey label on LCD.
USING LCD AND KEYPAD
Without configuration, the default idle screen (GXP2120) is like below.