Genee World GV-8100 - Manual (Page 7)

BASIC PREPARATIONS
1. Use one hand to hold the base of the visualiser, use the other hand to carefully lift
up the camera stand of the unit.
2. Open the arm lights and rotate the camera head until they are in proper positions.
3. Making connections:
Before making any connection, turn off all the power, including power of the visualiser
and the equipment to be connected.
Step 1: Connect power source.
First connect the power cord to the 12V IN connector.
The input format of projector’s control code is as follows:
a. If the data is in the numerical value format, please input data directly, block
them off with comma, do not distinguish lowercase and uppercase.
In the POWER ON box, input ’POWER 1’, 0d, 0a
(Remarks: There are 3 spaces after POWER, 0d, 0a is enter.)
Input other codes in the same way.
c. If the data is in the numerical value and character format, then synthesize
the above-mentioned formats.
3) Once done, click “Add” to add your projector model, then Click “Send”.
Afterward, click “Ok”. Now, you can use the visualiser to control your projector.
4. Connect the visualiser’s projector control port to the RS232 port
For example: the “POWER ON” code in Hitachi projector manual is :
In the POWER ON box, Input : be, ef, 03, 06, 00, ba, d2, 01, 00, 00, 60, 01, 00. Then use
the same input rule to input other code.
b. If the data is in the character string format, input ‘character string’.
For example: the “POWER ON” code in the SHARP C40/50 projector manual is :
BE EF 03 06 00 BA D2 01 00 00 60 01 00
P O W E - - - 1
(“-“ is space is enter.)