GBS Elektronik MCA-527 - Manual (Page 22)

MCA527
Table 3: Pinout of the Preamplifier Power Supply Connector (D-SUB9 female)
Contact Signal Front View
1 GND
2 GND
3 auxiliary analog input 1 5
4 +12V / 60mA max.
5 HV-Inhibit input 5 /
auxiliary analog input 2 5 /
thermistor input for NaI
detectors
5
6 -24V / 60mA max. 5
7 +24V / 60mA max. 5
8 1-wire interface (In / Out) 5
9 -12V / 60mA max.
shield GND
Gating Input
The gating input can be used to blank out specific pulses (e. g. LED-pulses from a
LED-stabilized NaI detector). It accepts 3.3V TTL pulses but is also 5V tolerant. This
connector is only available in the MCA527 and not in the MCA527L.
Table 4: Pinout of the Gating Input Connector (Lemo ERA.00.250.NTL)
Contact Signal Front View
1 (inner contact) gate input (TTL, 5V tolerant)
2 (outer contact) GND
RS232 Interface Connector
The RS232 connector is a 6-pin Lemo connector, the same as used with MCA166-USB.
This connector is only available in the MCA527 and not in the MCA527L.
5 Only available in MCA527 and not in MCA527L
22