GAMMA 5800 Els STRINGING MACHINE 2 POINT SC MOUNTING (Issue 1 - June 2006) - Manual (Page 9)

8
POWER CONNECTION & CONTROLS
Front Panel Features
A - String Gripper
B - Tension Button
C - L.E.D. Tension Display
D - Control Panel
Back Panel Features
A - 115 / 230 Volt Switch
B - Lighted Power Switch
C - A/C Power Cord Socket
D - String Length Meter Receptacle
E - 2 Amp Fuse Holder (w/ spare fuse)
F - 2 Pin Foot Pedal Switch Receptacle
B
C
A D
C
B
A
Instructions for Power Connection and Controls
CAUTION ! Before connecting to the power supply, check the voltage source
that the machine is being connected to. The acceptable range of input volt-
ages for this machine is between 100 V and 110 V @ 50 to 60 Hz. If you have any
questions regarding the input voltage supply for your area, please ask your electric
utility company.
To install the power cord, insert the female end of the power cord into the Power Cord
Socket located on the back panel and plug the male end into a grounded power outlet.
When using extension cords, use grounded heavy duty extension cords rated for 15
AMP service. To connect the foot pedal switch, insert the 2 pin female connector located at
the end of the foot pedal switch cord, into the two pin receptacle located in the back panel.
Tighten the connector with the sleeve nut located on the foot pedal switch connector.
After checking to be certain that the machine is connected to the correct input voltage,
switch on the machine by pressing the Lighted On-Off Power Switch on the side panel. At
start-up, the LED will display a countdown from “9.0” to “0.0” while the machine performs a
self diagnostics check at start-up.
WARNING!
FOR INDOOR USE ONLY. TO BE USED
BY ADULTS OR UNDER ADULT SUPERVISION ONLY.
NEVER OPEN UNIT WITH POWER CONNECTED
E
D
F