GAMMA 5800 Els STRINGING MACHINE 2 POINT SC MOUNTING (Issue 1 - June 2006) - Manual (Page 5)

Base Leg Assembly
The stringing machine uses a four leg base
design. The legs must be assembled to the
support post before use. Remove the lower
column support, the upper column support,
four (4) legs, four (4) socket head cap
screws and four (4) flat head cap screws
from the small shipping carton.
Base Leg Assembly (Cont.)
Align the holes in the leg flange with the
matching holes in the lower column support
post. Secure the leg with one flat head cap
screw through the upper hole, and one socket
head cap screw through the bottom hole.
Repeat this procedure for the three remain-
ing legs.
ASSEMBLY INSTRUCTIONS
Base Leg Assembly (Cont.)
To complete the base stand, screw the height adjust-
ment locking knob (“A”) into the side of the support
column. The locking knob should not protrude beyond
the inside of the support column at this time.
“A”
4