GAMMA 5800 Els STRINGING MACHINE 2 POINT SC MOUNTING (Issue 1 - June 2006) - Manual (Page 19)

MAINTENANCE and ADJUSTMENTS
Adjusting the String Clamp Jaw Spacing
The string clamps will need minor adjustments according
to what string type, construction, and gauge you are
using.
To adjust the gap (clamping pressure) between the clamp
jaws, insert the string through the racquet as if you were
beginning the main strings. Clamp the strings and pull
tension. If the string slips through the jaws of the clamp,
tighten the clamp by compressing the clamp jaws together
by hand while turning the Adjustment Knob, in the clock-
wise direction. If the clamp leaves impressions or dam-
ages the string, it may be excessively tight and should be
adjusted by turning the Adjustment Knob counter clock-
wise to open the gap between the jaws. The clamp jaws should be cleaned periodically to
be free from dirt, oil, and any string coating for them to grip properly. Knife sharpening stones
are excellent for removing build-up on the diamond coated surfaces and are available.
Note: The string clamps supplied with your stringing machine can accomodate tight string
patterns such as badminton. Depending on the string pattern, the clamp may spread the strings
slightly which will not compromise the quality of the string job. String clamps designed
specifically for badminton racquets are available.
Adjustment
Knob
18
Gripper Plate Spacing Adjustment
The parallel plates of the string gripper are
adjustable to accomodate varying string
gauges and types of string. If the string
slips through the gripper plates while pull-
ing tension, rotate the gripper adjustment
screw counter-clockwise. If the string is
damaged while pulling tension, rotate the
gripper adjustment screw clockwise. The
gripper is properly adjusted when there is
enough pressure to securely hold the string
without cuasing damage to the string.
Adjusting the Clamp Base Locking
Nut
In the event the Locking Lever rotation is
innsufficient to ensure smooth operation of
the clamp base, very minor adjustments to
the Clamp Base Locking Nut can be made
with a 17mm socket. Tighten or loosen the
locking nut in very small increments to pro-
vide more clamping pressure or running clear-
ance as needed.
Adjustment
Screw