GAMMA 5800 Els STRINGING MACHINE 6 POINT SC MOUNTING (Issue 3 - January 2009) - Manual (Page 7)

6
STRING REEL HOLDER INSTALLATION
The string reel holder pin is an 8 mm rod with
threads on both ends, and flat surfaces
machined on one end. Thread the end of the
pin without the flat surfaces into the threaded
boss on the right side of the lower column.
Using the M6 open end wrench positioned on
the flat surfaces, securely tighten the pin to
the lower column.
The string reel holder can hold up to 5 reels
of string (depending on the size of the string
reel). Before placing the first reel on the rod,
slide two M8 washers over the pin and slide
them to the boss on the lower column. After
the first reel is placed onto the rod, place two
spacers between each reel to provide
enough space between reels and allow
them to turn freely without rubbing against
one another. (To provide a smooth feed to
the String Length Meter, place the reels on
the rod so the string spools off the reel from
the underside of the reel.)
After the last reel is installed, place the
remaining spacer(s) on the pin and attach
the threaded knob to the end of the rod.