GAMMA 5800 Els STRINGING MACHINE 6 POINT SC MOUNTING (Issue 3 - January 2009) - Manual (Page 20)

19
MAINTENANCE & ADJUSTMENTS
Adjusting the String Clamp Jaw Spacing
The string clamps will need minor adjustments according
to what string type, construction, and gauge you are
using.
To adjust the gap (clamping pressure) between the clamp
jaws, insert the string through the racquet as if you were
beginning the main strings. Clamp the strings and pull
tension. If the string slips through the jaws of the clamp,
tighten the clamp by compressing the clamp jaws together
by hand while turning the Adjustment Knob, in the clock-
wise direction. If the clamp leaves impressions or dam-
ages the string, it may be excessively tight and should be
adjusted by turning the Adjustment Knob counter clock-
wise to open the gap between the jaws. The clamp jaws should be cleaned periodically to
be free from dirt, oil, and any string coating for them to grip properly. Knife sharpening stones
are excellent for removing build-up on the diamond coated surfaces and are available.
Note: The string clamps supplied with your stringing machine can accomodate tight string
patterns such as badminton. Depending on the string pattern, the clamp may spread the strings
slightly which will not compromise the quality of the string job. String clamps designed
specifically for badminton racquets are available.
Adjustment
Knob
Quick Action Clamp Base Removal
Quick Action clamp bases can be removed
from the turntable for maintenance or clean-
ing by removing clamp stop located at the end
of the slot in the turntable. To remove the
clamp stop, remove the two screws holding
the clamp stop in place from the underside of
the turntable. Lift the clamp stop out of the
slot, slide the clamp base to the end of the slot
and lift it out. Replace the clamp base and
clamp stop in reverse order.
Gripper Plate Spacing Adjustment
The parallel plates of the string gripper are
adjustable to accomodate varying string
gauges and types of string. If the string slips
through the gripper plates while pulling ten-
sion, rotate the gripper adjustment screw
counter-clockwise. If the string is damaged
while pulling tension, rotate the gripper ad-
justment screw clockwise. The gripper is
properly adjusted when there is enough
pressure to securely hold the string without
causing damage to the string. If you move
the gripper to the right hand end of the track
it is easier to access the screw.
Adjustment
Screw