GAMMA 5800 Els STRINGING MACHINE 6 POINT SC MOUNTING (Issue 3 - January 2009) - Manual (Page 6)

ASSEMBLY INSTRUCTIONS
5
Height Adjustment
The height of the machine is adjustable from
39” to 46” in approximate 1” increments. To
change the height, remove the socket head
cap screw from its current position and
place it in the appropriate hole to set the
desired height of the machine. Be sure to
thread the screw completely into the upper
column so the head of the cap screw rests
in the notch of the lower column.
Floor Stand Upper Column Installation
(cont.)
Secure the flange to the base of the machine
with the six M6 cap screws packed with the
floor stand.
USE CAUTION WHEN SECURING SCREWS
TO SLIDE BRACKETS. CROSS THREAD-
ING OR OVER TIGHTENING MAY DAMAGE
THE THREADS IN THE SLIDE BRACKET OR
CAUSE THE THREADS TO STRIP OUT.
Stand Upper Post Installation
With the height adjustment cap screw on the
upper column facing the brake lever & string
length meter, align the six holes marked “X”
in the upper column flange with the threaded
holes in the slide brackets of the machine
base.