GAMMA 5800 Els STRINGING MACHINE 6 POINT SC MOUNTING (Issue 3 - January 2009) - Manual (Page 10)

9
CONTROL PANEL FUNCTIONS
AND FEATURES
Single Digit (1-9)
Memory LED Display
Three Digit (XX.X)
Tension Setting Display
or String Length LED
Display
Lbs/Kgs Button - Changes tension
display from Lbs to Kgs. Each press of
the button toggles back and forth
between Lbs and Kgs.
Speed Button - Changes pulling speed
of winder from Fast (default) to Medium
to Slow. Slow speed is recommended
for low stretch strings, such as Kevlar.
Each press of the button toggles
between Fast, Medium and Slow
speeds.
Pre-Stretch Function - Pulls string 10%
or 20% over the tension setting (up to 90
lbs / 40.8 kgs), releases the string, and
repulls to the tension setting. Each press of
the button toggles between 10%, 20% or no
pre-stretch. String Length Meter Button - Enables
string length meter function. Each press
of the button toggles back and forth
between Meters and Feet measure-
ment. To switch back to tensioning
function, press the “Lbs/Kgs” button.
Clear Button - Clears display to enter a
new tension or to reset String Length
Meter measurement
Knot Function - Increases pulling tension by
10% over the setting value (max 90 lbs / 40.8
kgs) for one pull. During the pull the LED stays
lit to indicate the Knot function is enabled.
Tension Index Buttons - Changes
tension setting in +/- 1.0 or +/- 0.1 Lb or
Kg increments. Holding the button down
will scroll the tension setting values up
or down. Tension settings entered with
the tension index buttons are placed
into temporary memory setting “0”. Memory Button - Indexes from 9 preset
tension settings that can be stored in
memory. Settings are retained even if
machine is turned off. Each press of the
button indexes to the next memory setting.
Memory settings 1-9 must be entered using
the keypad followed by pressing the “ENT”
button.
Enter Button - Saves displayed tension for
Memory setting - when tension is entered
using the keypad display flashes until this
button is pressed to save the setting. Also
Clears display for String Length Meter
measurements
Test Button & Racquet Strung - Press
once for approximate number of racquets
strung. Press again to return. Press and
hold for 5 seconds and the machine does
an internal diagnostic check, such as the
one performed at start-up.