GAI-Tronics XCP0100A 4-Channel Expansion Kit - Manual (Page 4)

Pub. 43003-021E
Model XCP0100A 4-Channel Expansion Kit Page 4 of 7
f:\radio products-current release\43003\43003-021e\43003-021e.doc
03/12
6. Replace the rear cover and screws ensuring that no cables are pinched between the housing and the
rear cover.
7. Remove the seven screws securing the top panel and gently lift the cover to expose the attached
speaker cable and master display cable. See Figure 3.
Figure 3.
8. Disconnect the speaker cable at the male-to-female connection point. Unplug the master display
cable from the top cover.
9. Mount the new CSD PCBA next to the existing CSD board(s) using the supplied #4-40 screws. Refer
to Figure 3.
10. Connect the supplied CSD-to-CPM ribbon cable to J1 and route it under the cable slot nearest the
mounting position. Plug the other end of the cable into either P2 on the CPM board, if expanding a 4-
channel console, or P3 on the CPM board if expanding an 8-channel console.
11. Reassemble the front cover using the reverse procedure. Verify the correct ribbon cable positioning
before tightening the slave mid-panel mounting screws to avoid damage to the cable.
12. Refer to the CARD Suite Software (found on the XAC4000A Programming Bundle CD) for
programming instructions specific to the new channels.