GAI-Tronics 12251-002 Aluminum Weatherproof Cabinet Door Spring Modification Kit User Manual
Confidentiality notice, General information, Modification procedure
Pub. 42003-264A
GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA
610-777-1374
800-492-1212 Fax: 610-796-5954
V
ISIT WWW
.
GAI
-
TRONICS
.
COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Aluminum Weatherproof Cabinet Door
Spring Modification Kit
Model 12251-002
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
The Model 12251-002 Aluminum Weatherproof Cabinet Door Spring Modification Kit is designed to
replace the hinges on the following Page/Party
®
aluminum weatherproof enclosures with self-closing
spring-loaded hinges:
730-003 730-201 7305-201
730-005 703A
7305-003
730-101 7305-101 7305-006
The kit includes the following components:
Qty.
No.
Description
1 1 Spring,
double
torsion
1 2 Hinge pin, stainless steel, 0.25 inch diameter
3.4 inches long
2
3
Hinge pin retainer, 0.25 inch diameter
2 4 Washers, nylon 0.253 inch ID
0.50 inch OD 0.062 inch thick
Modification Procedure
1. Remove the lower hinge pin. (For units with a stainless steel pin, drive the pin out using a 7/32-inch
pin punch. For units with a Teflon
®
pin, cut the pin off below the pin retainer using a knife or chisel.)
Ream the hole using a 0.25-inch diameter drill bit.
2. Position the spring (#1) as shown in Figure 1. Align the coils of the spring with the hinge hole while
sliding the new hinge pin (#2) into the assembly. Place the nylon washers (#4) on the hinge pin.