GAI-Tronics 12703-001 EZ Page Speaker Voice Coil Kit - Manual

Pub. 42003-180A
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
EZ Page Speaker Voice Coil
Replacement Kit
Model 12703-001
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains sensitive
business and technical information that is confidential and proprietary to GAI-Tronics. GAI-Tronics
retains all intellectual property and other rights in or to the information contained herein, and such
information may only be used in connection with the operation of your GAI-Tronics product or system.
This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any third party.
General Information
The Model 12703-001 EZ Page Speaker Voice Coil Replacement Kit is used with the following EZ Page
Intercom models: GC-AC1, GC-DC1, and GC-AC2. Each kit consists of the speaker voice coil element
(4-ohm) only–no other parts are required.
Recommended Tools
• #1 Phillips screwdriver
• #2 Phillips screwdriver
• Flat blade screwdriver (1/4 × 4 min.)
• Long needle nose pliers
• Flat blade screw starter
Removal of Old Voice Coil Element
WARNING
Disconnect power from the unit before opening or servicing the unit.
N OTE : For ease of voice coil disassembly and re-assembly, remove the unit from its mounting and place it
on a flat surface.
1. Disconnect power from the unit.
2. Using the #2 screwdriver, remove the six front panel screws that secure the front cover to the housing.
3. Slowly pull the front cover assembly from the rear housing and set aside to the left. Be careful not to
disconnect the attached wires.
4. Locate and disconnect the P2 connector (2-conductor speaker connection) from the printed circuit
board assembly (PCBA).