D-Link DES-3208 - Manual (Page 74)

10/100 Fast Ethernet Switch User’s Guide
60
Using the Console Interface
5. Enter the desired Port Priority in the Port Priority (0-255) field.
6. Go to the SAVE command and save the STAP Port Parameters.
7. Choose EXIT to leave the STAP Port Parameters.
The PREPORT command allows you to see the parameters of the previous
port, and the NEXTPORT command allows you to see the parameters of the
next port
.
Figure 6-22. STAP Port Parameters
Resetting the Switch
You can use the console interface to reset the Switch stack, either doing a
System Reset (which restarts the Switch and is identical to powering the
Switch off and back on again) or a Factory Reset (which sets all of the
Switch’s parameters to what they were when the Switch was delivered from
the factory).