D-Link DES-3208 - Manual (Page 23)

10/100 Fast Ethernet Switch User’s Guide
Unpacking and Setup
9
♦
The FDX/Col LED indicators blink from yellow to green.
♦
The power LED indicator will light yellow while the switch loads
onboard software and performs a self-test. After approximately 20
seconds, the LED will light green to indicate the switch is in a ready
state.
♦
The console LED indicator will remain ON if there is a connection at
the RS-232 port, otherwise this LED indicator is OFF.
♦
The MII LED indicator will remain ON if there is a connection at the
MII port, otherwise this LED indicator is OFF. If there is an active
connection at the MII port, The MII LED, and the 100M and Link/Act
LED indicators for port 2x will remain ON, otherwise the Link/Act
LED indicators are OFF. The 100M LED indicator may remain ON
or OFF depending on the transmission speed.
♦
The System Load LED indicators will momentarily blink.
Power Failure
As a precaution, the Switch should be turned OFF in case of power failure.
When power is resumed, turn the Switch ON. At all times, avoid leaving the
Switch ON after the occurrence of a power failure.