GAI-Tronics 12533-001 Speaker Replacement Kit for 13350, 13351 - Manual

Pub. 42003-089A
GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Speaker Replacement Kit
Model 12533-001
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
The Model 12533-001 Kit includes the following components:
Qty Description
1 Speaker, 5-inch (16-watt, 8-ohm)
4 #8-32
× 5/16-inch Phillips machine screws
Installation
1. Loosen the six front panel captive screws.
2. Gently pull the front panel of the speaker away from the rear panel.
Model 13350: Disconnect the black and white quick-connect receptacles from the terminal block in
the rear enclosure.
Model 13351: Unplug the wire harness connector located below the speaker.
Model 13354-001: Disconnect the white and yellow quick-connect receptacles from the terminal
block in the rear enclosure.
3. Lay the speaker front panel on a flat surface. Disconnect the two quick-connect receptacles from the
speaker.
4. Remove the four screws securing the speaker.
5. Remove and discard the old speaker and screws.
6. Lay the new speaker in place on the panel gasket, making sure the quick-connect terminals are on the
bottom of the speaker.