GAI-Tronics 12550-001 Repl. Receiver Kits & Handset Amp for Page/Party - Manual (Page 2)

Pub. 42003-061C
M ODEL 12550-001 P AGE /P ARTY
®
R ECEIVER R EPLACEMENT K IT Page: 2 of 2
\\s_eng\gtcproddocs\standard ioms - current release\42003 kit manuals\42003-061c.doc
02/01
Installation of new receiver
1. Place receiver on a flat surface with the varistor facing down.
2. Remove the two screws in the receiver.
3. Place the board on the receiver with the antenna pointing up, away from the varistor.
4. Screw the board to the receiver with the green wire under the left screw where indicated.
5. Attach the red wire to the standoff in the center of the board.
6. Bend the silver antenna so that it is flat against the side of the receiver. Then bend the small end
around the corner so it is tight against the front of the receiver.
7. Hold the handset handle in the vertical position (receiver cavity at the top). Install the receiver
assembly into the cavity with the silver antenna bar at the five o’clock position.
8. Tighten the receiver cap.